Lots of users prefer graham crackers but once again, it is a matter of preference, but the spread you choose makes a BIG difference. Regardless of what you choose, make sure the crackers are large, flat, and thin. If you decide to use peanut butter or Nutella, it is best to pick a cracker with a low sugar content, unless of course, you have a massive sweet tooth! For a sugary taste sensation, use Nutella AND peanut butter!
In general, the spread should contain a high monounsaturated fat content. Your next piece of required equipment is aluminum foil. Make sure you have a large piece for each individual cracker. Before you begin, make sure you decarboxylate your marijuana. It is best if you finely grind it first before putting in the oven. The decarbing process converts inactive cannabinoids into active ones. For example, the THCA and CBDA in the weed will be converted into the effective THC and CBD we all know and love. Place your cannabis in the preheated oven at around 250 degrees Fahrenheit and leave it for 20 minutes.
Usually, the weed needs to be in the oven longer to fully decarb but remember, it will be in the oven again on the crackers so it will be fully activated when you have finished baking your edibles. You don’t need to decarb the weed if it has already been vaped or smoked in a joint. Grind the baked cannabis once again until it is ground into fine particles. Keep your oven on but increase the temperature to 325 degrees. Smear one side of the crackers with your chosen spread. One of the reasons why peanut butter is a good option is because its high fat content absorbs the THC from the cannabis. Spread your Nutella or peanut butter thickly on the cracker, but avoid spreading it to the edges as you don’t want your precious weed falling off while in the oven. Sprinkle the activated weed evenly on half of the crackers. It is best to use a knife or spoon for this purpose. Place each cracker that doesn’t have weed on top of the ones that have the herb to create a sandwich. You need to ensure the crackers are well sealed but avoid wrapping them so tightly that you cause them to crack. Put the wrapped crackers directly on a rack in the middle of the oven. We know you are eager to get stuck into your firecrackers, but you need to wait a few minutes and allow them to cool. Unwrap one of the firecrackers when they have cooled and enjoy! Remember, these are single dose edibles , so there is no need to be greedy and eat two or three. They are so delicious, however, that this is easier said than done! As you can plainly see, firecrackers are extremely easy to make. The entire preparation process only takes a few minutes. Despite their simplicity, they are very versatile because you get to choose the marijuana strain, the spread, and the type of cracker. Moreover, you also have full control over their potency. Firecrackers are an excellent method either getting stoned or using an alternative type of medicine, without exposing your lungs to combusted weed. You can also make THC-free firecrackers for kids if your goal is to provide them with a high dose of CBD to treat a medical problem. Just remember, it takes a while for the effects to kick in, so be patient!
Выполните вход, чтобы сообщить о неприемлемом контенте.
If you want to decarb, check out my new firecracker video: https://youtu.be/XZu1s5KSH2w. You do NOT need to decarb the weed first with this recipe because you are not wrapping the crackers in foil!