5 alive juice

Some of these products are good, some are not so good. I urge you to check them out before committing to a sale. Know what you are buying; research their record of Customer Support.

If you need assistance, contact me mailto:[email protected] It is time to start exposing Companies for what they are. But the company exaggerates the the LPM 200% of Faraday. Nothing special about their construction tolerances. The center (positive) plate will last half as long as the negative plates. It is assembled to get bombarded by electrons from both sides. Faraday calculates tis cell to produce 1.044 LPM @ 20 amps. This company makes several Cell designs, and sizes. But they are way out of line with their LPM capabilities.

I quote the late great Michael Faraday's Laws of Electrolysis on this page. As an example, this cell has 3x7 inch plates; 21 plates total; configured (+ n n n n - n n n n + n n n n - n n n n + ). They state it produces from 2LPM to 8LPM, using 12 to 30 volts, and 3 amps to 50 amps. Faraday calculations put this cell at producing about 1.9 LPM @ 36 amps, using 12v. Current Density is about 11.34 amps per stack, and there are 4 stacks. I have received numerous complaints about this product. Amperage / LPM is way overstated, and so is Current Density. https://aquatuneinternational.com/ Aqua Tune International. This is a water injection system that is advertised as also producing HHO. They offer absolutely no proof that it produces any HHO; no videos, no pictures of it in action. Their customer feedback repeatedly uses the words Tremendous, Astounding, Phenomenal, Awesome. If this unit could produce 47 LPM and also inject water into the combustion chamber, 4 cylinder engines would not need any gasoline if they used this product. I read their detailed page on "How It Works" I laughed my you know what off. If you bought this product and are not satisfied with it, or with the Customer Support they provided you, Please let me know. Contains nine 4x4 inch plates, configured + n n n - n n n + 3 volt plate voltage when operating on 12 volts. The main problem I have with this cell, is the use of only 1 hole in the plates. That single hole has to let water in, let water and HHO out; it restricts circulation. The holes are alternated top and bottom (one plate has the hole at the top, the next plate has the hole at the bottom. That causes this cell to Pulse the gas between chambers. As one chamber fills with gas, it pushes water out. The pulsing causes the water level to vary as the HHO fills the chamber and seeks a way out. In a sense, it collects HHO in some chambers before releasing it. The timing of this causes the out pulsing of the gas. It also causes an unequal distribution of the path amperage takes, and that introduces unnecessary heat which is definitely a problem with this cell.

It is a brilliant way of making a water heater out of a dry cell.

In the picture above, the HHO output port is far too low below the gasket. The chamber on the other side, has to fill with HHO - to that point - before it can escape through the hole. That happens from cell compartment to cell compartment; the worst dry cell design I have encountered. Using the Laws of Electrolysis of Water, given to us by the Late Great Michael Faraday, this cell is, at best, capable of producing about 752 ML PM @ 18 amps.


Get in touch